Replacing A Turn Signal Light Bulb; Replacing The Auxiliary Light Bulb - Yamaha YBR125 Custom Owner's Manual

1
1. Tail/brake light bulb
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
CAUTION:
Do not overtighten the screws, oth-
erwise the lens may break.
PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1
1. Screw
2. Remove the defective bulb by
ECA10680
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw.
CAUTION:
Do not overtighten the screw, other-
wise the lens may break.
EAU24202
Replacing the auxiliary light
bulb
If the auxiliary light bulb burns out, re-
place it as follows.
1. Remove the headlight unit by re-
1. Screw
2. Remove the socket (together with
ECA11190
6-31
moving the screws.
the bulb) by pulling it out.
EAU37270
6