Hints And Tips - AEG LAVATHERM 75476IH1 User Manual

7.13 Child lock function
The child lock can be set to prevent the
children to play with the appliance. The
child lock function locks all push buttons
and the programme dial (this function
does not lock On/Off button). To acti-
vate the child lock function push the Dry
Plus and Reverse Plus buttons at the
same time until the symbol
view on the display. To deactivate push
again the above buttons until the symbol
go out of view.
You can activate the child lock function:
• before you push the Start/Pause but-
ton - the appliance cannot start
• after you push the Start/Pause button
- all the push buttons and the pro-
gramme dial are deactivated
7.14 Starting a programme
To activate the programme push the
Start/Pause button. The LED above the
push button changes the colour to red.

8. HINTS AND TIPS

8.1 Ecological hints
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes which are speci-
fied in the programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the primary filter after each dry-
ing cycle.
7.15 Change a programme
To change a programme, push the On/
Off button to deactivate appliance. Push
the On/Off to activate the appliance and
then set the programme again.
7.16 At the end of programme
When the drying cycle is completed, the
come into
symbol flashes on the display. If the
Buzzer function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
1. Push the On/Off button for 2 sec-
onds to deactivate the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
• Clean the heat exchanger filters when
the applicable indicator comes into
the view on the control panel.
• Spin good the laundry before drying.
8.2 Water hardness and
conductivity
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust the
sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to availa-
ble programme.
ENGLISH
After each drying cycle:
13