AOpen MK73LE-N Easy Installation Manual page 5

10. Installing Front Audio
If the housing has been designed with an audio port on the front panel, you'll be able to
connect onboard audio to front panel through this connector.
Pin 1
1 2
GND
FP_MIC
+5V
FP_VREF
NC
PHONE_R
NC
NC
PHONE_L
9 10
11. Connecting CD / MODEM / AUX-IN
CD-IN
AUX-IN
MODEM-CN
The CD-IN connector is used to connect CD Audio
cable from CDROM or DVD drive to onboard sound.
The MODEM-CN connector is used to connect
Mono In/ Mic Out cable from internal modem card to
onboard sound circuit.
The AUX-IN connector is used to connect MPEG
Audio cable from MPEG card to onboard sound.
Connector Pin1 Pin2 Pin3
CD-IN Left GND GND
MODEM-CN Mono In GND GND
AUX-IN Left GND GND
12. Power-on and Load BIOS Setup
After you finish the setting of jumpers and connect correct cables. Power on
Del
and enter the BIOS Setup, press <Del> during POST (Power On Self Test).
Choose "Load Setup Defaults" for recommended optimal performance.
13. Installing LAN Driver (MK73LE-N Only)
You can install LAN Driver under Windows95/98, Windows NT and Windows 2000 for Realtek
RTL8139 Family (RTL8100 included) PCI Fast Ethernet adapter by following steps.
Installing driver procedure on Microsoft Windows 95 :
-----------------------------------------------------
1. Select "Driver from disk provided by hardware manufacturer" when being asked which driver you
would like to install.
2. Specify the setup file pathname
[CD-ROM]:Driver\LAN\RTL8100\Windows\Win95\WIN95A (for Windows 95 and Win95A) or
[CD-ROM]:Driver\LAN\RTL8100\Windows\Win95 (for Windows 95 OSR2).
3. Follow the procedure and insert Windows 95 system disk to complete setup step.
4. Windows 95 will finish the other installation procedures automatically, and then restart your
system.
Installing driver for Win98/Win98 SE/Windows2000/Windows ME :
-------------------------------------------------------------------
1. Select "Driver from disk provided by hardware manufacturer" when being asked which driver you
would like to install.
2. Specify the setup file pathname
Pin4
[CD-ROM]:Driver\LAN\RTL8100\Windows\WIN98 (for Windows 98/98 SE) or
[CD-ROM]:Driver\LAN\RTL8100\Windows\WIN2000 (for Windows 2000) or
Right
[CD-ROM]:Driver\LAN\RTL8100\Windows\Windows ME (for Windows ME)
Mic Out 3. Follow the procedure and insert your system disk (Win98/Win98 SE/Windows2000/Windows
ME) to complete setup step.
Right
4. Win98/Win98 SE/Windows2000/Windows ME will finish the other installation procedures
automatically, and then restart your system.
Warning: Please avoid using
"Load Turbo Defaults", unless you
are sure your system components
(CPU, DRAM, HDD etc.) are good
enough for turbo setting.