AOpen MX64 User Manual page 5

For Internal Modem Card (AOpen FM56-P):
1. Go into BIOS setup, Power Management
Enabled.
2. Setup your application, put into Windows 95.
3. Turn system power off by soft power switch.
4. Connect 4-pin Modem Ring-On cable from FM56-P RING connector to
MX64 connector WKUP.
5. Connect telephone line to FM56-P. You are now ready to use Wake On
Modem.
For External Box Modem:
1. Go into BIOS setup, Power Management
Enabled.
2. Setup your application, put into Windows 95 Start Up.
3. Turn system power off by soft power switch.
4. Connect RS232 cable of external box Modem to COM1 or COM2.
5. Connect telephone line to external box Modem. Turn on Modem power
(you must keep Modem power always on). You are now ready to use Wake
On Modem.
Tip: External 0V Wake On Modem signal is detected
through COM1 or COM2. Internal modem card wake up
signal is detected through cable from connector RING
(on modem card) to WKUP (on mainboard).
Note: If you use external modem, the power of external
modem must be kept on to receive signal from telephone
line. Internal modem card has no such limitation.
Overview
0V Wake On Modem, select
0V Wake On Modem, select
1-5