Table of Contents
Advertisement
56
What to do if ...
What to do if ...
The oven does not heat
up
The oven lighting is not
operating
Pyroluxe is not working
C1 REMOVE RUNNERS
appears in the clock dis
play
F11 appears in the clock
display
F2 appears in the clock
display
An error code not listed
above appears in the time
display
If you are unable to remedy the problem by following the above sugges
tions, please contact your dealer or the Customer Care Department.
Problem
The oven is not switched on
The clock is not set
The required settings have not
been set
The oven's safety cut out has
been tripped
The fuse in the house's electri
cal wiring (fuse box) has been
tripped
The oven bulb is faulty
Side rails/oven shelf runners
have not been removed
The meat probe has short
circuited or the plug of the
meat probe is not firmly in po
sition in the socket
Door not properly closed or
door lock defective
Fault in the electronics
Possible cause
Remedy
Switch the oven on
Set the current time on the
clock
Check the settings
See "Safety fuse"
Check fuse. If the fuses trip re
peatedly, please call an au
thorised electrician
Change the oven bulb
Remove side rails/oven shelf
runners
Insert the plug of the meat
probe as far as it will go into
the socket on the side wall of
the oven
Close door properly;
Turn the appliance off and on
again via the house fuse or
the safety switch in the fuse
box;
If displayed again, please con
tact the Customer Care De
partment
Switch off the appliance via
the house fuse or the safety
switch in the fuse box and
switch it on again
If displayed again, please con
tact your local Service Force
Centre
Advertisement
Table of Contents
