Suzuki VL800 Owner's Manual page 94

4. Place an accessory service
stand or equivalent under the
swingarm or chassis tubes to
stabilize the rear end.
5. Remove the cap 7.
6. Draw out the axle 8.
7. Remove the wheel from the
splined drive gear and set the
wheel assembly
ground.
8. Pull the wheel assembly rear-
ward.
9. To replace the wheel reverse
the
described above.
Failure to torque bolts and nuts
properly and to properly apply
thread lock to specified bolts
and nuts could lead to an acci-
dent.
Torque bolts and nuts to the
proper specifications. Properly
apply thread lock to specified
bolts. If you are not sure of the
proper procedure, have your
authorized SUZUKI dealer or a
qualified mechanic do this.
Rear axle tightening torque:
65 N·m (6.5 kgf-m, 47.0 lbf-ft)
Rear torque link nut
tightening torque:
25 N·m (2.5 kgf-m, 18.0 lbf-ft)
NOTE: Apply a drop of SUZUKI
THREAD LOCK "1322" to the rear
frame mounting bolt 1, 2.
Rear frame mounting bolt
tightening torque:
50 N·m (5.0 kgf-m, 36.0 lbf-ft)
on the
7-38
complete
 WARNING
sequence