Starting A Dishwashing Cycle - AEG FAVORIT 88080 Vi User Information

Starting a dishwashing cycle

1. Check that the spray arms can turn freely.
2. Turn the water tap on fully.
3. Press the ON/OFF button.
4. Use the direction buttons (
The name of the selected rinsing cycle will flash. The predicted duration
of the cycle is displayed to the right of the cycle name.
5. Press the OK/START button.
6. Close the door. The dishwashing cycle will begin.
A light signal in the form of a dot appears at floor level.
3
If the dishwasher is built in at high level with flush fitting cupboard
doors, the light signal cannot be seen.
The dot shaped light signal is not dangerous. (It is not a laser.) It lights
up while a dishwasher cycle is running and goes out when the cycle
ends.
In the text display you will see the name of the current stage of the cy-
cle. Beside this you will see the predicted time remaining in minutes.
The OPTION button allows you to briefly view the name of the rinsing
cycle in the display.
3
A rinsing cycle can only be started from the cycle menu.
3
During the rinsing cycle, the remaining time shown on the display is
adjusted according to the size of the load, degree of soiling, etc.
3
You cannot make changes to the options or settings while a rinsing cy-
cle is in progress.
Interrupting or aborting a dishwashing cycle
Only interrupt a dishwashing cycle that is in progress if it is absolutely
necessary.
Interrupting the dishwashing programme by opening the dishwash-
er door
1
Hot steam may escape when the door is opened. There is a risk of scald-
ing.
1. Open the door carefully. The dishwashing cycle will stop, in the display:
PLEASE CLOSE DOOR
2. Close the door. The cycle will continue.
30
or ) to select the cycle required.