Starting The Wash Programme; Wash Programme Progress; Changing The Wash Programme - AEG LAVAMAT W 1450 ELECTRONIC User Information

Starting the Wash Programme

0 1. Check that the stopcock is open.
2. Starting the wash programme: Press the START/
PAUSE (MARCHE/PAUSE, START/PAUZE) button.
The wash programme starts.
If the END (FIN/EINDE) light flashes 4 times and at the same time an
3
acoustic signal sounds 4 times when the START/PAUSE (MARCHE/
PAUSE, START/PAUZE) button is pressed, the door is not closed properly.
If this happens, push the door firmly closed and press the START/PAUSE
(MARCHE/PAUSE, START/PAUZE) button again.

Wash Programme Progress

Programme Progress Display
Before the programme starts, the steps to be carried
out are indicated on the Programme Progress Display.
During the wash programme, this indicates the cur-
rent stage of the programme.

Changing the Wash Programme

Changing or cancelling the programme
1. Press the START/PAUSE (MARCHE/PAUSE, START/PAUZE) button.
2. Turn the programme knob to OFF (ARRET/UIT). The wash programme is
cancelled.
3. Set another wash programme, if required. Otherwise, turn the pro-
gramme knob to DRAIN (VIDANGE/POMPEN) or SPIN (ESSORAGE/
CENTRIFUG.) and press the START/PAUSE (MARCHE/PAUSE, START/
PAUZE) button. (The water is drained or the washing is spun.)
The wash programme can be interrupted at any time by pressing the
3
START/PAUSE (MARCHE/PAUSE, START/PAUZE) button. It is then re-
started by pressing the button again. A wash programme can only be
changed after the programme knob has been turned to OFF (ARRET/
UIT).
Instructions for use
23