Rear Wheel Removal; Rear Wheel Installation - Yamaha TW200E Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
2
5
4
3
1. Adjusting nut
4
2. Brake rod
3. Axle nut
4. Cotter pin
5
5. Chain adjusting plate

Rear wheel removal

6
w
7
8 It is advisable to have a
Yamaha dealer service the
8
wheel.
8 Securely support the motorcy-
9 cle so there is no danger of it
falling over.
1. Remove the brake adjusting
nut and brake rod from the
brake cam lever.
2. Remove the axle nut cotter pin
and loosen the axle nut.
3. Elevate the rear wheel by plac-
ing a suitable stand under the
2
engine.
3
4. Remove the axle nut.
5. Push the wheel forward and
remove the drive chain.
6. Pull out the axle and remove
the rear wheel assembly by
pulling it backwards.
EAU01304
EW000122

Rear wheel installation

6-33
1. Install the wheel assembly and
insert the axle from the left-
hand side. Be sure that the
chain adjusting plates
installed with the punched side
outward and the slot in the
brake shoe plate is fit over the
stopper on the swingarm.
2. Install and adjust the drive
chain. (See page 6-22 for
details about adjusting the
drive chain slack.)
3. Install the axle nut and let the
motorcycle down.
4. Tighten the axle nut to the
specified torque and install the
axle nut cotter pin.
Tightening torque:
Axle nut:
90 Nm (9.0 m0kg)
EAU01308
are