To Change The Engine Oil - Yamaha MT-03 Owner's Manual

CAUTION:
Do not operate the vehicle until you
know that the engine oil level is suf-
ficient.
WARNING
0
Never remove the engine oil tank
cap after high-speed operation,
otherwise hot engine oil could
spout out and cause damage or in-
jury. Always let the engine oil cool
down sufficiently before removing
the oil tank cap.
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Install the oil filler cap.
PERIODIC MAINTENANCE AND MINOR REPAIR
ECA10010

To change the engine oil

(with or without oil filter element
replacement)
1. Start the engine, warm it up for
several minutes, and then turn
it off.
EWA10360
2. Place the motorcycle on its side
stand, then place an oil pan under
the oil tank and another under the
engine to collect the used oil.
3. Remove the engine oil filler cap
and the drain bolt to drain the oil
from the crankcase.
4. Remove the drain bolt to drain the
oil from the oil tank.
1. Engine oil crankcase drain bolt
2. Engine oil tank drain bolt
5. Remove the oil filter element
6-9
drain bolt to drain the oil from the
oil filter element.
1
2
3
4
5
6
7
8
9
10