Sidestand - Yamaha MT-03 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
3. Tighten the locknut to the speci-
fied torque.
1
Tightening torque:
Locknut:
2
45 Nm (4.5 m·kgf, 32.5 ft·lbf)
3
CAUTION:
4
Always tighten the locknut against
the adjusting nut, and then tighten
the locknut to the specified torque.
5
6
7
8
9
10
WARNING
0
This shock absorber contains high-
ly pressurized nitrogen gas. For
proper handling, read and under-
stand the following information be-
fore handling the shock absorber.
The manufacturer cannot be held
responsible for property damage or
ECA11240
personal injury that may result from
improper handling.
G
Do not tamper with or attempt
to open the gas cylinder.
G
Do not subject the shock ab-
sorber to an open flame or oth-
er high heat sources, otherwise
it may explode due to exces-
sive gas pressure.
G
Do not deform or damage the
gas cylinder in any way, as this
will result in poor damping per-
formance.
G
Always have a Yamaha dealer
service the shock absorber.
EWA10220

Sidestand

1. Sidestand
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the motorcycle upright.
NOTE:
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See further down for an expla-
nation of the ignition circuit cut-off sys-
tem.)
3-18
EAU15301