Azden PCS-6000H Instruction Manual page 8

5. Setting Shift Width and Direction: When 'F' indicator comes on after the 'F' '~witch
pressed, pressing the 'SHIFT' key will indicate +(6) that means transmission occurs at
6UOkHz above the receiving frequency. Furthermore, when the 'F' indicator on, pressing
the 'SHIFT' key will indicate —(5) that mean'; 'transmission occurs at 600kHz below the
receiving frequency.
The plus and minus shift is not activated in the M. (Memory) Mode.
Shift with other than 600Hz can he programmed to any optional
value. Refer to 'How To Program' at page 9
Note: When the M Mode indicator is lit, shift key operation is disabled.
6 Reverse Mode Operation (REV)' When the 'REV' key is pressed and 'REV' indicated on
the display during repeater operation, the transmit and
receive frequency's are reversed. To disable the reverse mode operation, push the RF:V
key again and the RFV indicator is turned off to indicate that the reverse mode is disabled.
7. How to operate Tone: When 'F' indicator is lit (after the 'F' switch is pushed) pressing
the TONE key will activate tone encoder and the 'TONE' indicated on the display.
Repeating the same procedure will turn the TONE off and the TONE indicator comes off.
Note : 1 ) The tone key operation is disabled when tone code( s ) are not programmed in
the computer.
2) Refer to 'How To Program' for tone code programming.
3) The tone function is automatically activated when the tone code is pre—
programmed in memory channel.
4) Use the 'TONE' key to disable tone operation.
-7-