Load Sensing - Sensor Logic; Switching Off The Dishwasher; Emptying The Dishwasher - AEG FAVORIT 80860 i User Instructions

Operating Instructions
Changing the start delay:
As long as the wash programme has not started, you can still change
the start delay set by pressing the DELAY TIMER button b.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.

Switching Off the Dishwasher

Only switch the dishwasher off when the multi-display indicates "0" for
the remaining programme time and
gramme progress display.
If the acoustic signal has been switched on there will be a continuous
signal for 5 seconds at the end of the wash programme.
1. Press the ON/OFF switch.
0
All indicators go out.
Hot steam may escape if the door is opened immediately after the end
1
of the programme. Therefore:
2. Open the door carefully.

Emptying the Dishwasher

• Hot dishes can be sensitive to knocks. The dishes should therefore be
3
allowed to cool down before removing them from the appliance.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• Empty the lower rack first, then the upper rack. This will avoid any
water left on the upper rack dripping onto the dishes in the lower
rack and causing water spots.
30
L
is illuminated on the pro-