Table of Contents
Advertisement
A
X
4
G
E
T
u
b
e
/
A
A
X
4
G
E
T
u
b
e
/
A
To confirm that the driver has been properly loaded in Windows Me, perform the following steps:
1. Choose "Settings" from the "Start" menu.
2. Choose "Control Panel," and then double-click on the "System" icon.
3. Choose the "Device Manager" tab, and then click the "+" in front of "SCSI & RAID controllers". "Win98-ME Promise SATT150
TX2plus(tm) IDE Controller" should appear.
****************************************************
Installing Drivers During Windows 98 SE Installation
****************************************************
The following details the installation of the Serial ATA drivers while installing Windows 98 SE (with the SATA controller is enabled already).
1. After enabling the Serial ATA controller and configuring the hard drive(s), partition and format your hard drive(s), if necessary.
2. Install Windows 98 SE normally.
3. After installation, go the "Start" menu and choose "Settings."
4. From the "Settings" menu, choose "Control Panel."
5. In the "Control Panel" window, double-click on the "System" icon.
6. In the "System" window, choose the "Device Manager" tab.
7. In the hierarchical display under "Other Devices" is a listing for "PCI Mass Storage Controller." Choose it and then press the
"Properties" button.
8. Choose "Reinstall Driver," and then press "Next."
9. Choose "Search for a better driver than the one your device is using now (recommended)," then press "Next."
X
4
P
E
T
u
b
e
X
4
P
E
T
u
b
e
94
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
