Table of Contents
Advertisement
A
X
4
G
E
T
u
b
e
/
A
A
X
4
G
E
T
u
b
e
/
A
a. Floppy install: boot the system with the Windows NT installation diskettes.
b. Floppyless install: boot from floppy and type "WINNT /B". After files have been copied, the system will reboot. On the reboot, press
the "F6" key when the message "Setup is inspecting your computer's hardware configuration..." appears.
c. c. CD-ROM disk install: boot from the CD-ROM disk and press
computer's hardware configuration..." appears.
2. When the "Windows NT Setup" window is generated, press "S" to specify an Additional Device(s).
3. Use "↑" or "↓" to select "Other" and press the "Enter" key.
4. Insert the driver diskette into drive A: and press the "Enter" key.
5. Choose "WinNT Promise SATA TX2plus (tm) IDE Controller" from the list that appears on screen, and then press the "Enter" key.
6. The Windows NT Setup screen will appear again saying, "Setup will load support for the following mass storage devices:" The list will
include "WinNT Promise SATA TX2plus (tm) IDE Controller".
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified, continue to the next
step -
7. From the Windows NT Setup screen, press the Enter key. Setup will now load all device files and then continue the Windows NT
installation.
After a successful installation, the "SCSI Adapter Setup" box will show that the "WinNT Promise SATA TX2plus (tm) IDE Controller" driver
has been installed.
***********************************************
Installing Drivers with Existing Windows NT 4.0
X
4
P
E
T
u
b
e
X
4
P
E
T
u
b
e
the "F6" key when the message "Setup is inspecting your
91
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
