Step 2 Set Jumpers; Step 3 Install Ddr Sdram System Memory - AOpen MK77M-V User Manual

Step 2.
Set Jumpers
This mainboard is jumperless! The default jumper settings have been set for
the common usage standard of this mainboard. Therefore, you do not need
to reset the jumpers unless you require special adjustments as in any of the
following cases:
1. Clear CMOS
2. BIOS Protection
3. CPU Frequency
For first-time DIY system builders, we recommend that you do not change the
default jumper settings if you are not totally familiar with mainboard configu-
ration procedures. The factory-set default settings are tuned for optimum
system performance. For the advanced users who wish to customize their
system, section 3.2 Jumper Settings will provide detailed information on how
to configure your mainboard manually.
Step 3.
Install DDR SDRAM System Memory
To install memory, insert SDRAM memory module(s) in any one or two or
two DIMM banks. Note that SDRAM modules are directional and will not go
in the DIMM banks if they are not properly oriented. After the module is fully
inserted into the DIMM bank, lift the clips of both sides of the DIMM bank to
lock the module in place.
- 13 -