Back Panel; Supplying Power - Honeywell Dolphin 7600 User Manual

Back Panel

Power Supply Connector
Attach the power supply to this connector. The universal power supply accepts input voltages
between 90-265 volts.
Power Switch
Toggle the power switch to turn the charger on and off.

Supplying Power

Use the power adapter cable that comes with the charger so that the input voltage is adjusted
appropriately.
1. Locate the AC power adapter cable and plug it into the power source.
2. Connect the power cable to the power adapter.
3. Connect the power cable to the power supply connector on the back of the charger.
4. Press the power switch to the ON position.
5. The device performs the following power-up diagnostic routine for each slot indicated by the Status
LEDs:
• All ON Orange
• delay (500ms)
• All ON Red
• delay (500ms)
• All ON Green
• delay (500ms)
• All OFF
12 - 2
Power Supply Connector
Power Switch