Table of Contents
Advertisement
3. S
ETUP
AC Power
This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line voltage
to which you are connecting it is within the range of accepted voltages.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0
to 100% switch.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture's specifications chart. A fixture's listed current rating indicates its
average current draw under normal conditions.
Always connect the fixture to a circuit with a suitable electrical ground.
Fixture Linking (COLORtube™ 3.0 EQ)
The COLORtube™ 3.0 EQ has both signal and power linking. Please see the diagram below for a description
on how to link these fixtures.
(Optional)
Signal
COLORtube™ 3.0 EQ User Manual
Signal In
8
Power In
4/5/2010 11:04 AM
Power
Advertisement
Table of Contents
