Using The Transceiver As A Base Station - Radio Shack HTX-10 Owner's Manual

Caution: Do not connect the black wire to a non-metallic
(plastic) part, or to any part insulated from the vehicle's
chassis by a non-metallic part.
3. Connect the single connector end of the power cord to the
connector on the back of the transceiver.
USING THE TRANSCEIVER AS A BASE
STATION
Although this transceiver is designed mainly for mobile use, you
can also use it as a base station with an AC power source. For
base station installation, you need these items.
• a 12-volt DC power supply that can supply at least 7 amps
Caution: Most 12-volt DC power supplies plug into a stan-
dard AC outlet to produce DC power. Before connecting
your transceiver to a 12-volt DC power supply, read and fol-
low the instructions included with the power supply.
• base station antenna
• coaxial antenna cable and connectors
• external 8-ohm speaker
Note: Your local RadioShack store carries everything you
need to use the transceiver as a base station.
14