Before Using For The First Time; Setting/Changing The Time - AEG COMPETENCE B 8100 Operating Insructions

Operating Instructions

Before using for the first time

Setting/Changing the Time

Following the connection of mains power the TIME function indicator
and the temperature/time display flash.
You must then set the time. The time can be set with the appliance
either switched on or off.
If the time has not been set, the oven cannot be operated.
3
Setting the Time
1. Press the + or - button and set the time as required.
0
Each time the + or - button is pressed the time moves forward or
back one minute respectively.
2. Press the clock W button or wait approx. 5 seconds.
The time displayed in the temperature/time display ceases to flash and
is displayed continuously. The time is now set.
By pressing the + or - button for more than 2 seconds, the minutes
3
will start to run forwards or backwards until the button is released
again. By this means you can reach the required setting quicker.
If the appliance has been isolated from the mains, e.g. due to a power
3
failure, the temperature/time display will flash again.
In this case reset the time again, as described above.
16