Inset Ceiling Mounting - Axis 231D User Manual

Inset Ceiling Mounting

AXIS 231D mounted in bracket
Follow these instructions to mount the dome camera:
1. Place the decoration ring on the ceiling and mark the three screw holes and the inner
circle of the decoration cover.
2. Cut the hole in the ceiling according to the markings.
3. Insert the mounting bracket in the ceiling with the holders folded in. Once in place,
fold out the holders over the inner ceiling and secure the bracket by tightening the
screws.
4. Connect the connection module cable from the dome body to the external
connection module.
5. Connect the Ethernet cable and connection module to the AXIS 231D.
6. Connect the power cable and check that the power and network LEDs light up
(green).
7. Push the dome body up into the installed bracket and twist it clockwise to lock it
into the bracket.
8. Make sure the screw hole on the side of dome is aligned with the bracket. Tighten the
fixing screw to secure the dome.
9. The hardware installation is now complete, proceed to the next section to install the
AXIS 231D on your network.
Fixing screw
Network
connector
Connection
module
connector
Decoration ring
AXIS 231D - Installing the AXIS 231D
Ceiling
9