Gigabyte GA-8I925X-G User Manual page 72

Installing the RAID drivers
For the Windows operating system (Win NT, WinXP, Win2000 ), for IDE RAID/SCSI/Serial ATA functioning,
the driver must first be transferred to a floppy disk. Please follow the steps below to complete driver transfer
to a floppy disk:
1) Please insert the provided driver CD into the hard disk drive eg. Drive D:
2) Insert a blank formatted floppy disk into the floppy disk drive.
3) Either from "Command Prompt" or DOS, please type in "D:\BootDrv\menu.exe"(Refer to Fig.1)
4) Information on all chipsets should be listed on the screen (Refer to Fig.2), please select the proper
chipset model.
Fig.1
Fig.2
(Note)
Your system will then automatically zip and transfer this driver file to the floppy disk.
After you complete the steps, boot from the Windows CD to install the RAID drivers.
When install Windows 2000 or Windows XP from HDDs in serial ATA controller, press F6 as Win2000 or XP
boots up, then supply serial ATA controller driver by this floppy disk. Follow on-screen instructions to
complete installation.
(Each time you add a new hard drive to a RAID array, the RAID driver will have to be installed under
Windows once for that hard drive. After that, the driver will not have to be installed.)
Note: In the menu list, Intel Application Accelerator 4.0 is Intel ICH6R chipset.
GA-8I925X-G Motherboard - 72 -