Installation - Fortec Star Lifetime User Manual

2 OPERATION

4. Installation

In this section, you will learn how to use the
Antenna Set-up, Scan, and Edit Channel and TP data.
4.1 Antenna Setup
4.1.1 Satellite
• Scroll to the satellite you want to program by using the ▲▼keys.
• Select the satellite you want by pressing ◄►key. A check mark will
appear next to the satellite to show that it is selected. You can de-select it
again by pressing ◄►key once more. If you press OK, the satellite will
be selected and that satellite's sub-menu will appear.
• From the satellite's sub-menu, you can adjust the LNB type, LNB Lo-
Freq., 22kHz, DiSEqC, LNB power, TP, and Positioner Setting.
4.1.2 LNB type
• Select proper LNB type using ◄►keys according to the LNB type you
are using. The default settings are the Fortec Star Universal LNB
(Universal 1). All settings for the LNB type are shown below:
22KHz control is automatically set for each LNB alternative. If Universal 1
or 2 is selected, 22Khz control should be in the "off state".
4.1.3 LNB Lo-Freq
When the required LNB frequency is not available, select "Standard" and then
input the frequency value with the numeric keys.
4.1.4 22KHz
When you are using a Dual LNB or two antennas connected to a 22KHz tone
switch box, set 22KHZ tone switch "ON" for one dish and set 22KHz tone
switch to the "OFF" mode for the other dish.
4.1.5 DiSEqC
• Full DiSEqC
If a DiSEqC switch is used, select the port number that corresponds to the
output of the DiSEqC switch.
16
o Universal 1 (975MHz & 10600 MHz)
o Universal 2 (975MHz & 10750 MHz)
o Single-SL (5150MHZ & 5750 MHz)
o Single SH ( 5150MHz & 5750 MHz)
o Standard (9750MHz; the value can be manually changed)