Husqvarna EZ 17 Operator's Manual page 58

4. Deck outer spindle
Lubricate using a grease gun, one zerk, each
side 2-3 strokes.
Use only good quality bearing grease.
5. Engine Oil
Changing the Engine Oil
The engine oil should be changed for the first
time after 5-8 hours of operation. Thereafter,
it should be changed every 50 hours.
WARNING!
Engine oil can be very hot if it is
drained directly after stopping
the engine. Allow the engine to
cool somewhat first.
1. Place the machine on a flat surface.
2. Place a container under the engine where
the hose from the oil drain valve exits.
3. Remove the dipstick and open the drain
valve.
4. Allow the oil to run out into the container.
5. Then close the oil drain valve.
6. Replace the oil filter if necessary.
7. Fill with new engine oil in accordance with
Checking the Oil Level.
8. Start the engine. Run it for a few seconds.
Stop and re-check the oil level.
56-
English
LUBRICATION
Deck outer spindle
IMPORTANT INFORMATION
Used engine oil is a health hazard and
must not be disposed of on the ground
or in nature; it should always be
disposed of at a workshop or
appropriate disposal location.
Avoid skin contact; wash with soap
and water in case of spills.
Oil drain valve
8011-733
8011-730