Samsung SCO-2081R Series User Manual page 28

Setup
COMM ADJ (Communication Adjustment) : This function sets up the camera
communication status when controlling the camera through an external control device.
➊ When the SPECIAL menu screen is
displayed, press the Function Setup
switch so that the arrow indicates
'COMM ADJ'.
➋ Set up the mode using the Function
Setup witch.
- CAM ID : Determines the camera's
- BAUD RATE : You can select 2400/48
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : Determines whether to send a command back to the controller device
- DISP ID : Display camera ID on top left corner of the screen.
- PROTOCOL : You can select one of various protocols. SAMSUNG-T,
Initial value of communication adjustment
Item
Initial value
RETURN : Select this to save the SPECIAL menu settings and return to the MAIN

SETUP menu.
EXIT
Select a desired EXIT mode using the Function Setup switch depending on the camera purpose.
 sAVe : Save the current settings and exit the MAIN SETUP menu.
 NOT sAVe : Do not save the current settings and exit the MAIN SETUP menu.
: Resets the camera settings to the factory defaults. Monitor, Language
 ReseT
and COAX settings are not initialized.
28_ Setup
identifi cation number
(between 0 and 255).
00/9600/19200/38400/57600 bps.
when a communication control command is sent to the camera.
SAMSUNG-E, PELCO-D , PELCO-P, BOSCH, HONEYWELL,
VICON, PANASONIC, GE, AD.
Camera ID
1
COMM SETUP
1. CAM ID
2. BAUD RATE
3. UART MODE
4. RET PKT
5. DISP ID
6. PROTOCOL
7.
RETURN
BAUD RATE UART MODE
9600 8-N-1
1
IIIIIIIIIIIIIIIIIIIIIIIIIIIII
9600
8-N-1
ENABLE
OFF
SAMSUNG-T
PET PKT
ENABLE