Chrysler TOWN & COUNTRY 2009 Owner's Manual page 172

170 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
11. Select Remote Linked to Memory in the Electronic
Vehicle Information Center (EVIC). Refer to the "Customer-
Programmable Features" in the "Electronic Vehicle Infor-
mation Center (EVIC)" section for more information.
12. Repeat the above steps to set the next Memory
position using the other numbered Memory button or to
link another RKE transmitter to memory.
Memory Position Recall
NOTE: The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the vehicle is not
in PARK, a message will be displayed in the EVIC.
To recall the memory settings for driver one, press Memory
button 1 on the driver's door or the UNLOCK button on
the RKE transmitter linked to memory position 1.
To recall the memory setting for driver two, press Memory
button 2 on the driver's door or the UNLOCK button on
the RKE transmitter linked to Memory Position 2.
A recall can be cancelled by pressing any of the memory
buttons on the driver's door during a recall (S, 1, or 2).
When a recall is cancelled, the driver's seat, driver's
mirror, and the pedals stop moving. A delay of one
second will occur before another recall can be selected.
To Disable RKE Transmitter Linked to Memory
1. Turn the ignition switch to the OFF position and
remove the key.
2. Press and release Memory button 1. The system will
recall any memory settings stored in position 1. Wait for
the system to complete the memory recall before continu-
ing to Step 3.
3. Press and release the memory SET (S) button located
on the driver's door. A chime will sound signaling that
you are in the memory set mode.