Panasonic TH-42LF30ER Operating Instructions Manual page 43

Item
Locks the input switch operation.
Off
* "SLOT INPUT" is displayed when an optional Terminal Board is installed.
Input lock
Notes:
• Only the adjusted signal is displayed (see page 16).
• Input switch can be used when this is set to "Off".
Off
Off: All the buttons on main unit can be used.
MENU&ENTER: Locks
On: Locks all the button on main unit.
Button lock
Sets Button lock with the unit buttons in the following procedure.
Off: Press
MENU&ENTER: Press
On: Press
Off
Off: You can use all of the buttons on the remote control.
User1: You can only use
Remocon User level
User2: You can only use
User3: Locks all the buttons on remote control.
Enable: Enables the "Off-timer function".
Off-timer function Disable: Disables the "Off-timer function".
Note: When "Disable" is set, the Off-timer is cancelled.
Normal
Sets the power mode of the unit for when the power recovers from failure or after plugging off and in again.
Normal: Power returns in as the same state as before the power interruption.
Initial Power Mode
Standby: Power returns in standby mode. (Power Indicator : red/orange)
On:
Note: When using multiple displays, "Standby" is preferred to be set in order to reduce a power load.
Sets panel ID number when panel is used in "Remote ID" or "Serial ID".
Set value range: 0 - 100
ID select
(Standard value: 0)
The setting of this menu is valid only when using ID remote control.
Off: Disables ID remote control functions. You can use normal remote control operations.
On: Enable ID remote control functions.
Remote ID
Note: To use the ID remote control function, it is necessary to set each ID number of remote control and
Sets the panel ID Control.
Serial ID Off: Disables external control by the ID.
On: Enables the external control by the ID.
Sets the top and end of a daisy chain when the SERIAL terminal of Display is daisy chained.
---: When the Display is under SERIAL control on a standalone basis, or if not at the top or end of daisy
Serial Daisy Chain
Top: To connect to the top of daisy chain.
End: To connect to the end of daisy chain.
Off: Nullify all the settings adjusted.
Studio W/B On: Sets the colour temperature for TV studio.
Note: Valid only when the "Warm" is set as "White balance" in Picture menu.
Off
Off: Power is not transmitted to the slot power.
Auto: Power is transmitted to the slot power only when main power is on.
Slot power
On: Power is transmitted to the slot power when main power is on or in the standby state.
Note: In some cases, power is transmitted to the slot power when main power is on or in the standby
SLOT INPUT* VIDEO
On MENU&ENTER
MENU ENTER/
and
four times Press
ENTER/
four times Press
four times Press
User1 User2
, ,
button on the remote control.
On Standby
Power returns in power On. (Power Indicator : green)
display unit. About the setting method, please refer to "ID Remote Control Function" (see page
36) and "ID select" (above-mentioned).
chain.
Auto On
state regardless of the slot power setting.
Adjustments
Component/RGB
buttons on main unit.
INPUT
four times Press four times Press
four times Press
ENTER/
four times Press four times Press
User3
, , buttons on the remote control.
Options Adjustments
PC DVI HDMI1
ENTER/
INPUT
four times Press
ENTER/
HDMI2 Off
ENTER/
43