BT RESPONSE 15 + User Manual page 18

Help
Check that your BT Response 15 Plus is
correctly connected to the mains and
that the power cable is inserted correctly
into the back of your BT Response 15
Plus.
If you have inserted the back-up battery
before connecting to the mains power you
will need to reset your BT Response 15
Plus.
Is the telephone cord plugged into the
back of the BT Response 15 Plus unit?
Is the BT Response 15 Plus cord
plugged into the wall socket?
This indicates an error. Press any button
on your answering machine. Flashing
should stop and the answering machine
should reset to its settings on first 'power
up'. Unplug the line cord and power cord.
Wait 5 minutes and then replug.
The back-up battery is either low in power,
missing or incorrectly installed. Open the
battery compartment which is located on
the underside of the unit. If the battery
is correctly in place, try replacing it with
a new 9V alkaline battery. When
16
Response 15+_Issue 2_Edition 1_3.10.03
operating at normal power the battery
light remains off.
If a working battery is installed inside
your answering machine, its settings
and messages should be saved until
power resumes. It will not be able to
record any new messages, however.
Your BT Response 15 Plus' volume may
be set too low. Adjust the volume by
pressing
Your answering machine is too close to
a radio, TV, computer, cordless or mobile
telephone, causing interference. Move it
another metre away.
Make sure your BT Response 15 Plus is
set to answer-on mode and that the
memory is not full. When the memory is
full, the display will flash F.
Make sure that the telephone you are
using to access your BT Response 15
Plus has a TouchTone
When entering your code, make sure
you allow enough time, at least 2
seconds, between digits for your BT
Response 15 Plus to recognise each one.
on the volume control.
keypad.
TM