Table of Contents
Advertisement
A
K
7
7
-
6
0
0
M
a
x
A
K
7
7
-
6
0
0
M
a
x
Promise FastTrak 378 Windows NT 4.0 Installation Guide
*******************************
New Windows NT 4.0 Installation
*******************************
1. Start the system installation by booting from the Windows NT disk:
a) Floppy install: boot the system with the Windows NT installation diskettes.
b) Floppyless install: boot from floppy and type "WINNT /B". After files have been copied, the system will reboot. On the
reboot, press the "F6" key when the message "Setup is inspecting your computer's hardware configuration" appears.
c) CD-ROM disk install: boot from the CD-ROM disk and press the "F6" key when the message "Setup is inspecting
your computer's hardware configuration " appears.
2. When the "Windows NT Setup" window is generated, press "S" to Specify an Additional Device(s).
3. Press "O" to select "Other" and press the "Enter" key.
4. Insert the Promise Technology FastTrak 378 driver diskette into drive A: and press the "Enter" key.
4a. Insert the Bonus CD in CD-ROM. Type "[CD-ROM]:\Driver\Promise\PDC20378\Driver\nt4" in the text box that
appears. Press " OK ".
5. Choose "Win NT Promise FastTrak 378 (tm) Controller" from the list that appears on screen, then press the "Enter" key.
6. The Windows NT Setup screen will appear again saying "Setup will load support for the following mass storage devices:" The
list will include "Win NT Promise FastTrak 378 (tm) controller".
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified,
107
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
