Table of Contents
Advertisement
SYSTEM CONNECTIONS
Choose either Wireless or Wired connection, then follow the appro-
priate instructions.
WIRELESS
Connecting the Subwoofer for Wireless Applications
ID
CODE
DC18V
1 2 3 4
1. Connect a subwoofer cable from the subwoofer or LFE output of
your receiver to the Sub
on the transmitter.
2. Plug the transmitter module's power supply into the wall outlet,
and connect the included power cord to the transmitter
sure the Transmitter Antenna
3. Set the ID code on the transmitter and subwoofer (
the same position, as described on page 6. When connected prop-
erly, the LED on the top of the subwoofer will be orange.
4. Set the Low-Pass Selector
NOTE: Some receivers have two subwoofer outputs. In that case,
use either connector.
SUBWOOFER OR
LFE OUTPUT
Sub In
. Make
is extended upward.
and
) to
to the "Off" position.
WIRED
Connecting the Subwoofer for Wired Applications
If you have a Dolby
®
Digital or DTS
with a low-frequency-effects (LFE) or subwoofer output:
SUBWOOFER OR
LFE OUTPUT
Level
Crossover
Wireless
O
O
ff
ff
O
O
n
n
ID Code
Low-Pass
Low-Pass
L
R
LFE
Sub In
Line In
If your receiver/processor does not contain a Dolby Digital
or DTS processor, but has subwoofer outputs:
NOTE: If your receiver/processor has only one sub out, you may use
either the L or R input.
®
receiver/processor
[Hz]
RECEIVER/PROCESSOR
Level
Crossover
[Hz]
Wireless
O
ff
O
n
ID Code
Low-Pass
L
R
LFE
Sub In
Line In
5
Advertisement
Table of Contents
