j6758bk02.book Page 72 Friday, January 28, 2005 8:02 AM
NOTICE:
6 Connect the power cable to the system board (see page 51).
7 Locate the data cable from the CD or DVD drive in the upper drive bay and connect its
middle data connector to the new drive.
8 Reattach the front panel (see page 61).
9 Replace the computer cover (see page 74).
NOTICE:
the computer.
10 Connect your computer and devices to electrical outlets, and then turn them on.
11 See the documentation that came with the drive for instructions on installing any software
required for drive operation.
Battery
CAUTION:
located in the Product Information Guide.
NOTICE:
from your body before you touch any of your computer's electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
72
Removing and Installing Parts
Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
power cable
To connect a network cable, first plug the cable into the network wall jack and then plug it into
Before you begin any of the procedures in this section, follow the safety instructions
To prevent static damage to components inside your computer, discharge static electricity
first CD/DVD
connector
(primary drive)
second CD/DVD
connector (secondary
drive)