Chapter 3 — Operation
Route the media through the slits in the front edge guides
7
Firmly close the top cover.
8
If loading media for the first time or if changing from another type or
9
size of media, perform a Label Gap Sensor Adjustment as described
on page 28. Else, tap the Feed key either 4 times or until the indicator
lamp glows green.
If the printer did run out of media while printing, the printing will
10
automatically be resumed. Else, tear off excessive media by pulling it
upwards against the tear bar.
Tear off the media upwards against the tear bar.
20
EasyCoder PC4 User's Guide