Replacing The Label Mark Sensor - Intermec 3600 Maintenance Manual

3600 Printer Maintenance Manual
3. Unplug the Kanji/Katakana PCB from the main PCB using a gentle rocking
4. Install the new Kanji/Katakana PCB onto the main PCB, making sure the
5. Install the electronics cover, the media cover, and the power cord, and

Replacing the Label Mark Sensor

To replace the label mark sensor, you will need the following parts and tools:
To replace the label mark sensor
1. Switch off the printer power and remove the power cord.
2. Remove the media cover, the electronics cover, and the front bezel cover
3. Raise the printhead. Remove media and ribbon if loaded.
4. Remove the screws securing the lower outboard plate to the printer and
5-10
motion while pulling it away.
pins are properly aligned with the connector and that the Kanji/Katakana
PCB is fully seated before tightening the screws.
check the printer for proper operation.
Label mark sensor cable assembly, Intermec Part No. 061578-001
Roller alignment tool, Intermec Part No. T43150
ESD grounding strap
#1 and #2 Phillips screwdriver
(refer to "Replacing the Bezel PCB" earlier in this chapter).
pull it away from the printer. Retain the tear bar and tear bar support.
Tear bar
Tear bar
support
Lower outboard
plate
3600M.048