Table of Contents
Advertisement
PROBLEM
• The battery is exhausted.
No power comes ON.
• Bad connection to the battery pack.
• Squelch level is too deep.
No sound comes from
• Volume level is too low.
the speaker.
• Speaker has been exposed to water.
Transmitting is impos-
• Some channels are for low power or re-
sible, or high power
ceive only.
can not be selected.
• The battery is exhausted.
• The output power is set to low.
The display channel
• Lock function is activated.
cannot be changed.
Scan does not start.
• "TAG" channels are not programmed.
No beeps sound.
• Beep tones are turned OFF.
POSSIBLE CAUSE
TROUBLESHOOTING
SOLUTION
• Recharge the battery pack.
• Check the conection to the transceiver.
• Set squelch to the threshold point.
• Set [OFF/VOL] to a suitable level.
• Drain water from the speaker.
• Change channels.
• Recharge the battery pack.
• Push [H/L] to select high power.
• Push [H/L •
] for 1 sec. to cancel the
LOCK
function.
• Set the desired channels as "TAG" chan-
nels.
• Turn the beep tones ON in SET mode.
9
REF.
p. 15
p. 3
p. 6
p. 7
—
pgs.
2,4
p. 15
p. 2
p. 2
p. 11
p. 13
17
Advertisement
Table of Contents
