Uniden DSS7855 Owner's Manual page 11

B. Connect the base unit
1) Connect the AC adapter to the DC IN 9V
and to a standard 240VAC wall outlet. Connect
the AC adapter to a continuous power supply
(i.e., an outlet that is not controlled by a switch).
2) Set the base on a desk or tabletop, and place
the handset in the base unit. Place the base
unit close to the AC outlet so that you can
unplug the AC adapter easily.
3) Make sure that the charge LED illuminates. If
the LED does not illuminate, check to see that
the AC adapter is plugged in and the handset
makes good contact with the base charging
contacts.
4) After install the battery pack in the handset,
charge your handset for at least 15-20 hours
before plugging into the phone line.
5) Once the handset battery pack is fully charged,
connect the telephone line cord to the
LINE jack and to a telephone outlet. If your
telephone outlet isn't modular, contact your
telephone company for assistance.
jack
TEL
[10]
Use only the
!
supplied [AAD-
041S] AC adapter.
Do not use any
other AC adapter.
Do not place the
!
power cord where
it creates a trip
hazard or where it
could become
chafed and create
a fire or electrical
hazard.