Table of Contents
Advertisement
Setting Surface Controls (cont'd)
Sabbath Feature Mode
When the Sabbath feature is ON, all electronic surface element control displays show "Sb". The surface
elements can be used even if the Sabbath Feature is on.
To activate the Sabbath Feature Mode:
In order to enter Sabbath at least one radiant burner has to be active. The user has to activate the
(timer up slew) pad and the
To turn ON an additional Surface Element when the Sabbath Feature is active:
If you turn on a surface element when the Sabbath feature is on, the electronic surface element control will record that
request and execute it with a 15-30 seconds delay. So the element will start heating 15-30 seconds after the surface element
control was turned on. The surface element display will not show the setting because "Sb" is on in the displays. When
necessary, it is possible to adjust the power of the surface element but you have to remember that the surface element
control will adjust the temperature with the same delay. Note: No element size change is allowed during Sabbath. If
needed, it has to be changed prior to Sabbath entry.
To turn OFF the Surface Element when the Sabbath Feature is active:
To shut off the surface element while the Sabbath feature is ON, proceed as usual but take note that the element will
immediately turn off and the display will show «HE» without any delay. Note: Only the individual On/Off keys can be used
to turn Off any element. Power On/Off key will be disabled and cannot be used during Sabbath.
To deactivate the Sabbath Feature Mode:
Touch and hold
(timer up slew) pad and the
from timer and element control displays. The cooktop is now in its normal operation mode.
If a power failure happens when Sabbath mode is active:
The unit wakes up in Ready mode with all displays lit. "SF" (Sabbath Failure) will be displayed on the power level indicators.
You will be able to turn ON any element by activating its "On/Off" key pad for half second and setting the power level
using the
or
pad. The size of a turned On element will be the same as the size selected prior to power loss (or Single
by default).
Warm & Hold Feature
The Warm & Hold feature may be used with any of the Cooking Elements.
To Turn the Warm & Hold Feature ON:
1.
To select the Warm & Hold feature for any Cooking Element touch the
Element.
2. Touch the
key pad located in the main control area. The associated display will show LH (low heat) indicating
that the Cooking Element is properly set to Warm & Hold. If no other key pads are pressed the control will activate the
desired Cooking Element at the Warm & Hold setting.
Locking the controls
The Cooktop Controls can be locked in order to prevent the cooktop from accidentally being turned ON. This feature can be
activated only when no cooking zone is active. If the cooktop is in use, it will not be possible to lock the controls.
To Turn ON the Controls Lock Feature:
Touch and hold the
key pad. After a few seconds a beep will sound. The Lock Indicator Light above the
ON indicating the cooktop is locked. This will keep any Cooking Element or Cooktop functions from being accidentally turned ON.
Note: If the cooktop is in used when the Control Lock Feature is activated, the command will be ignored.
To Turn OFF the Controls Lock Feature:
Touch and hold the
will turn OFF indicating the cooktop is unlocked. The Cooking Elements or any of the other Cooktop functions may now be
used.
(lock) pad at the same time for a few seconds. Timer and element displays will show "Sb".
key pad. After a few seconds a beep will sound. The Lock Indicator Light above the
(lock) pad at the same time for a few seconds. "Sb" will disappear
13
key pad for the corresponding Cooking
key pad will turn
key pad
Advertisement
Table of Contents
