Table of Contents
Advertisement
ENGLISH
<STANDARD> <DSP SIMULATION>
<POWER>
QUICK SELECT
About the button names in these explanations
<
>
: Buttons on the main unit
[
]
: Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
0
Quick Select Function
With this function, the currently playing input source, input mode,
surround mode, room EQ settings and volume can be stored in
the memory.
1
Set the input source, input mode, surround mode,
room EQ settings and volume to the conditions you
want to store.
2
Press and hold the desired
Keep pressing the button until the quick select indicator lights.
QUICK SELECT
Quick Select 1
Quick Select 2
Quick Select 3
• To call out the settings, press QUICK SELECT at which the desired
settings were stored.
• The Quick Select name can be changed (vpage 32).
NOTE
Input sources stored with the quick select function cannot be selected
if they have been deleted at menu "Manual Setup" – "Option Setup"
– "Source Delete" (vpage 31). In this case, store them again.
Personal Memory Plus Function
This function sets the settings (input mode, surround mode, etc.)
last selected for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone control, room EQ settings and the
volumes of the different speakers are stored for the individual surround
modes.
QUICK SELECT
.
[Quick Select Defaults]
Input Source
Volume
DVD
–40 dB
TV/CBL
–40 dB
VCR
–40 dB
Last Function Memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to
their default values.
1
<POWER>
Turn off the power using
2
<POWER>
Press
while simultaneously pressing
<STANDARD>
<DSP SIMULATION>
and
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
.
.
Advertisement
Table of Contents
