Advertisement
WARNINGS
• Carefully read the instruction booklet.
• This appliance must be only used in the home.
It must not be used for any other purpose, nor
modified or tampered with in any way.
• Before using, check that the mains voltage
corresponds to the voltage indicated on the
appliance rating plate located under the motor
head.
• Connect the appliance only to power outlets
with a minimum rating of 10A. Make sure the
outlet is earthed. In the case of appliances with
double insulation (see the symbol
specifications label) earthing is not required.
• Always unplug the appliance from the power
socket when not in use or before performing
any maintenance or cleaning operations on
the appliance.
• DO
NOT
clean
trichloroethylene or other solvents.
• DO NOT tug on the power cord to disconnect
the appliance from the mains outlet.
• DO NOT leave the appliance unattended when
running. Keep it out of the reach of children or
persons unfit to use it.
• DO NOT run the appliance over the power
cord, to avoid damaging the insulation
• DO NOT vacuum up inflammable or corrosive
liquids.
• DO NOT vacuum up matches, ash or cigarette
butts when still alight.
• Vacuuming up large quantities of fine ash and
dust may compromise the proper operation of
the filtering system.
• DO NOT use the appliance if it appears to be
faulty.
• Special care must be taken when using the
appliance to clean stairs
• For repairs or the purchase of accessories,
contact an authorised Service Centre only.
The manufacturer reserves the right to modify the
appliances and the accessories supplied without
prior notice.
Only use original spare parts and accessories so
as to maintain the appliance in good working
order and NOT invalidate the guarantee
This
appliance
complies
ELECTROMAGNETIC
COMPATIBILITY
89/336 and the EEC LOW VOLTAGE directive 72/23.
12
on the
the
appliance
with
with
the
EEC
directive
ASSEMBLY AND PREPARING FOR USE AS A
WET/DRY VACUUM CLEANER
Note: when assembling and preparing for use,
make sure that the appliance is NOT plugged into
the power outlet.
• Completely lower the handle that blocks the
motor head T (Fig. 1).
• Remove the motor head F (Fig. 2).
• Remove the wet/dry tank H using the handle
on the tank (Fig. 3).
fig. 1
fig. 2
fig. 3
Advertisement
