Turning On The Power - Canon CF-1 Operating Manual

000_L-IE-5152E_CF-1.book Page 43 Monday, July 29, 2013 10:30 AM
Check that the EOS digital
camera is firmly attached and
the cables are connected
correctly.

7.1.2 Turning ON the Power

Always perform the inspections shown in the following sections to ensure proper function before use.
! CAUTION
7.1.2.1 Check Items on the Behaviors of the Equipment
Turn on the power of all the equipment that has been connected as a system and check the following items.
Check whether the POWER
lamp lights.
Check that there is no dirt or
scratches on the objective
lens.
Place a sheet of paper in front
of the objective lens, turn the
brightness adjuster, and check
that the brightness for
observation changes.
Place a sheet of paper in front
of the objective lens and press
the shutter release button to
check that the flash is emitted.
Set to fluorescein
angiography mode and press
the TIMER/C switch to check
that the timer starts and stops
properly.
Inspection Month
Day
Pass/
Fail
For safety reasons, be sure to inspect the instrument before using it.
Inspection
Month
Day
Pass/
Fail
Pass/
Fail
Pass/
Fail
Pass/
Fail
Pass/
Fail
-43-
7. Daily Inspection and Maintenance
Result
Month Month
Day Day
Contact your sales representative
Pass/ Pass/
or local Canon dealer if there is a
Fail Fail
problem.
Result
Month Month
Day Day
Contact your sales representative
or local Canon dealer if the
Pass/ Pass/
POWER lamp fails to light even
Fail Fail
though the power cable is
connected properly.
Clean the lens if it is dirty (see
page 48).
Pass/ Pass/
Contact your sales representative
Fail Fail
or local Canon dealer if it is
scratched.
Contact your sales representative
Pass/ Pass/
or local Canon dealer if there are
Fail Fail
no changes.
Contact your sales representative
Pass/ Pass/
or local Canon dealer if no flash is
Fail Fail
emitted.
Contact your sales representative
Pass/ Pass/
or local Canon dealer if there is a
Fail Fail
problem.
Continued on the following page >>
Remedy
Remedy