Drying Sequence - Electrolux EDE401E Instruction Booklet

i

Drying sequence

Before starting up for the first time it is advisable
lo load a few moist cloths into the dryer and to let
it run for about 30 minutes. This ensures that no
dust and dirt is left in the drum. In order to do
this, switch the machine on by pressing the
ON/OFF button, set the programme selector dial
on "L", then press the START button.
The programme will start and finish
automatically.
To dry your laundry:
1. Connect the tumble dryer.
2. Load the items one at a time, shaking them
out loosely and close the door.
3. Press the ON/OFF button
light lights up.
4. Select the required drying programme.
5. Press button and/or button
6. Press the START-button: the selected
programme will start and light
illuminate.
All the drying programmes end with a cooling
phase which lasts 10 minutes (the corresponding
light illuminates).
If the laundry is not removed at the end of the
programme, the machine will automatically
perform the anti-crease phase which lasts about
30 minutes.
During this period the buzzer will sound every
10 seconds, unless you have depressed the
button. The lights
alternatively.
Turn the programme selector dial to "O", switch
the machine off by depressing ON/OFF button
again and remove the laundry.
If this is not done, at the end of the anti-crease
phase the tumble dryer will automatically stop
functioning, light will flash and the Mains-On
light remains alight.
64
, the mains-on
if required.
will
and flash
After each use
I
Press the ON/OFF button again to switch the
dryer off. The mains-on light goes out.
I
Turn the selector dial to "O".
I
Clean the fluff filter (see page 66).
M0043s