Table of Contents
Advertisement
Assembly instructions
Fitting the decor panel
Preliminary requirement: the overall dimensions of
the decor panel must be 1-2 mm less than those of
the door, with a maximum thickness of 4 mm. With
the refrigerator door closed, unscrew the screws
securing the removable side piece of the frame to
the door. Remove this side piece and slide the decor
panel into place, after having slackened the
remaining frame screws; push the panel fully home
and secure the frame to the door, including the side
piece previously removed.
Door reversal
Right hand door opening
Remove the upper and lower screws (1) and pivots
(2) with the safety washer (4) on the left side (Fig.).
Remove the door stop hinge (3-Fig.).
Left hand door opening
Remove the upper right screw and pivot. Straighten
the safety washer (4) of the lower right hinge.
Remove the screw (5) and the pivot (6) (Fig.). For
safety reasons bend the washer located under the
left hinge (Fig.), by using a tool (for ex. a screw
driver). Remove the right door stop hinge (3-Fig.).
Fitting the handle
Holes for fitting the handle on the opposite side are
provided, with fixing screws already in place.
1
2
D561
3
D562
6
4
5
D563
6
4
5
39
Advertisement
Table of Contents
