What To Do If; Troubleshooting By Yourself - Electrolux EDH6370 User Information

What to do if ...

Troubleshooting by your-
self
If, during operation, the error code (E plus number or
letter) appears on the multi-display: Switch the ma-
chine off and on again. Reset programme. Press the
START/PAUSE button
If the error is still displayed, please inform our after-
sales service and quote the error code.
Problem
Dryer does not work.
Drying results unsatisfactory.
Loading door does not close.
When a button is pressed,
Err appears in the multi-dis-
play.
Drum light does not work.
PROGRAMME TIME
(LAUFZEIT) display changes
erratically or stays unchanged
for a long time.
Programme inactive, EMPTY
WATER (BEHÄLTER) display
illuminated.
Possible cause
Mains plug is not plugged in or fuse
is not working correctly.
Loading door is open.
Have you pressed the START/
PAUSE button?
Wrong programme selected.
Lint filter clogged.
Fluff filter blocked with fluff.
Incorrect volume of laundry.
Ventilation slots in base area cov-
ered up.
Residue on inside surface of drum or
drum ribs.
Fine strainer not in place and/or
large mesh filter not locked in place.
Washing protection. After the start of
the programme, the option can no
longer be set.
Programme selector in OFF (AUS)
position.
Defective light bulb.
Programme time is corrected auto-
matically depending on type and
volume of laundry and level of
dampness.
Condensate tank is full.
Remedy
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door.
Press the START/PAUSE button again.
Select a different programme the next
time you dry (see "Overview of pro-
grammes" section).
Clean lint filter.
Clean the fluff filter.
Observe recommended loading vol-
umes.
Uncover ventilation slots in base area.
Clean inside surface of drum and drum
ribs.
Make an adjustment using the INTEN-
SITY (RESTFEUCHTE) function (see
chapter "Drying, Selecting additional
functions").
Install fine strainer and/or snap large
mesh filter into place.
Turn the programme knob to OFF
(AUS). Set the programme again.
Turn programme selector to LIGHT (BE-
LEUCHTUNG) or to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty condensate tank, then start pro-
gramme with START/PAUSE button.
19