Table of Contents
Advertisement
5. Position the runners (H) at the top and bottom of the
inside of the kitchen unit as shown in the figure and
mark the position of the external holes.
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
6. Open both the appliance door and that of the
kitchen unit to approx. 90°.
Place the little platee over the runners. Hold the
doors of the appliance and the unit together and
mark the holes.
7. Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little plates over the
runners and screw in the screws provided (3.5x16
mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that the
doors of the appliance and the kitchen unit open
properly.
H
D094
8mm
PR34
PR35
22
Advertisement
Table of Contents
