Setting A Programme - Electrolux EWS1266EDW User Manual

14 www.electrolux.com
Bleach
Alternatively the softener, it is also possible to use a bleach agent in the compartment
with the programmes for white cottons.
Proceed as follows:
• Put the bleach in the compartment
tergent dispenser drawer.
• Run a programme for white cottons.
• At the end of the programme, run the programme RINSE. Use softener, if desired.
This helps to eliminate any bleach residues.
Never pour bleach and softener into the compartment at the same time.
9.3 Activating the appliance
Press the On/Off button to activate or de-
activate the appliance. A tune sounds
when the appliance is activated.

9.4 Setting a programme

1. Turn the programme knob and set
the programme:
– The related programme indicator
comes on.
– The indicator of the
– The display shows the level of the
Time Manager, the programme du-
ration and the indicators of the pro-
gramme phases
2. If necessary, change the temperature,
the spin speed, the cycle duration, or
add available options. When you acti-
vate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message Err.
9.5 Starting a programme
without delay start
Press
• The indicator
stays on.
• The indicator
display.
• The programme starts, the door is
locked and the display shows the indi-
cator
• The drain pump can operate for a short
time when the appliance fills water.
:
stops to flash and
starts to flash on the
.
. Do not exceed the «MAX» mark in the de-
9.6 Starting a programme with
delay start
• Press
flashes.
play shows the delay you want to set.
The related indicator comes on the dis-
play.
• Press
– The appliance starts the countdown.
– When the countdown is completed,
To cancel the delay start:
1.
2.
9.7 Interrupting a programme
and changing the options
You can change only some options be-
fore they operate.
1.
2.
3.
After approximately 15 minutes
from the start of the programme:
• The appliance adjusts automati-
cally the programme duration
agree with the laundry load.
• The display shows the new val-
ue.
again and again until the dis-
:
the programme starts automatically.
You can cancel or change the set
of the delay start before you press
.
Press to set the appliance to
pause.
Press until the display shows
Press again to start the pro-
gramme immediately.
Press . The indicator flashes.
Change the options.
Press again. The programme con-
tinues.
'.