Table of Contents
Advertisement
Rear spacers
The plastic bag containing all relevant
documentation also contains two spacers to be
fitted into special holes in the back of the
appliance. Fit the spacers into the holes, taking
care to ensure that the arrow (A) is positioned as
shown in Figure. Then turn them through 45°
(arrow (A) vertical) until they lock into place.
Door reversibility
Before starting work, unplug the appliance. To
reverse the opening direction of the door
proceed as follows:
remove the lower hinge (3), pin (1) and foot (2);
unscrew the front left foot and screw it back in on
the opposite side;
remove the two screws which mask the holes for
fixing the hinge from the front left hand side;
reassemble the door;
refit the lower hinge (turning it through 180°), the
pin and the foot on the opposite side, as shown
in the figure.
Remove the handles, after having removed the
screw cover and refit it on the opposite side. The
holes that are not used must be masked with the
plastic plugs removed.
Warning:
After having reversed the opening direction
of the doors check that all the screws are
properly tightened and that the magnetic seal
adheres to
the cabine".
temperature is cold (i.e. in Wınter), the gasket
may not fit perfectly to the cabine". In that case,
wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the serial number plate
correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For
operation with different voltages, a suitably sized auto-transformer must be used.
The technical data is indicated in the rating plate on the left side inside the appliance.
12
If the ambient
TECHNICAL SPECIFICATION
A
45
PR60
D590
2
D299
PR228
Fig. 2
Fig. 3
D
Fig. 4
1
3
2
Fig. 5
GB
Advertisement
Table of Contents
