Table of Contents
Advertisement
If this appliance featuring magnetic door seals
is to replace an older appliance having a
spring lock (latch) on the door or lid, be sure
to make that spring lock unusable before you
discard the old appliance. This will prevent it
from becoming a death-trap for a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Best performance is obtained with
ambient temperature between +18°C and +43°C
(class T); +18°C and +38°C (class ST); +16°C
and +32°C (class N); +10°C and +32°C (class
SN). The class of your appliance is shown on
its rating plate.
that air can circulate freely around the back of the
cabinet. To ensure best performance, if the
appliance is positioned below an overhanging
wall unit, the minimum distance between the top
of the cabinet and the wall unit must be at least
100 mm (Fig. 1-A). Ideally, however, the
appliance should not be positioned below
overhanging wall units (Fig.1-B). Accurate
levelling is ensured by one or more adjustable
feet at the base of the cabinet.
It is essential that the appliance be connected to
an efficient earth tap. For this purpose the supply
cable plug incorporates a special earth contact. If
the sockets of your domestic wiring system are
not earthed, have the appliance connected to a
CONTENTS
11
11
12
11
12
12
12
13
13
13
13
13
INSTALLATION
separate earth wire by a qualified electrician in
accordance with existing safety regulations.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio
interference suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent mod)fications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
moddfications.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly. Do not use detergents or
abrasive powders, as these will damage the finish.
This appliance complies with the following
E.E.C. Directives:
A
B
NP007
GB
14
14
14
14
15
15
16
16
16
16
16
16
GB
Fig. 1
11
Advertisement
Table of Contents
