Operating Sequence - Electrolux EWF695 Operating Instructions Manual

Operating sequence

Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer in order to activate the ECO
valve. Then run a cotton cycle at 90°C, with the
machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you have selected the prewash, pour detergent
into the appropriate compartment marked
3. Measure out the additive
If required, pour fabric softener into the
compartment marked
«MAX» mark.
4. Select the desired programme
Turn the programme selector dial to the desired
position .
.
.
, without exceeding the
The light "Start/Pause" button starts to flash.
5. Select the required options
The light corresponding to the depressed button
illuminates.
6. Select the
To delay starting of a programme, press the
"Delay Start" button, before starting the machine,
until the light corresponding to the required delay
illuminates.
8 h
4 h
8. Start the programme
Depress "Start/Pause" button, the
corresponding pilot light stops flashing and stays on.
The door is locked. If you have selected the
"Delay start", the machine starts its hourly
countdown.
During this time it is possible to modify the selected
programme (temperature, spin and options) only
after you have set the machine in PAUSE.
9. Altering an option or a programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the
button.
Changing a running programme is possible only by
resetting it.
52
+
"Delay Start" option
"Start/Pause"