Roland M-380 Owner's Manual page 21

Editing the Engineer's Monitor
preference settings
1.
Access the M-48 MANAGER popup.
2.
Press [F6 (ENG MON SETUP)].
fig.M48_EngMonSetup.eps
The M-48 ENGINEER'S MONITOR SETUP popup will appear.
You can set the following items:
• SOLO MODE select button
• LAYER select clears SOLO
• LINE OUT MONO select button
• MONITOR-ONLY select button
By checking the MONITOR-ONLY select button, the Engineer's
Monitor works just for audio monitoring, and it does not control the
musician's mix.
The LINE OUT SOURCE select button and the LINE OUT LPF select button
follows the settings of the musician's side.
Setting the M-48 mix option
The MIX OPTION has been added to the M-48 Source Assign popup. By checking the "MIX only Assigned Sources" select button, only sources assigned to a
group will be mixed to the M-48's MAIN buses.
You cannot check the "MIX only Assigned Sources" select button if the system program version of the M-48 is prior to 1.01.
1.
Access the M-48 MANAGER popup.
2.
In the M-48 list, move the cursor to the desired M-48 unit
and press [F2 (SETUP)].
fig.M48_Setup.eps
The M-48 SETUP popup will appear.
1PS
MEMORY operation on the Engineer's Monitor is not allowed.
Releasing the Engineer's Monitor
1.
Access the M-48 MANAGER popup.
2.
Press [F8 (ENG MON SETUP)].
fig.M48_EngMonSetup.eps
The M-48 ENGINEER'S MONITOR SETUP popup will appear.
3.
Press [F8 (RELEASE ENG MON)].
A message will ask you to confirm the operation.
4.
Press [F8 (RELEASE)] to release the ENGINEER'S
MONITOR.
3.
Press [F4 (SOURCE ASSIGN)].
fig.M48_SrcAssign.eps
The M-48 SOURCE ASSIGN popup will appear.
4.
Move the cursor to the MIX only Assigned Sources select
button in the MIX OPTION, and press [ENTER].
A message will ask you to confirm the operation.
5.
Press [F8 (CHANGE)] to check/uncheck.
Functionality added in version 1.11
21