Table of Contents
Advertisement
WARNING
An unbalanced garage door might not reverse
when required and someone under the door
could be seriously injured or killed.
If your garage door binds, sticks or is out of
balance, call for professional garage door
service. Garage doors, door springs, cables,
pulleys, brackets and their hardware, are
under extreme tension and can cause serious
injury or death. Do not try to loosen, move or
adjust them yourself!
Ropes left on a garage door could cause
someone to become entangled and killed.
Remove all ropes connected to the door before
installing and operating the opener.
Identify the type and height of your door, any special
conditions that exist, and any additional materials that
may be required, by referring to page 4.
Hex Screw 5/16"-18 x 7/8" (4)
Hex Screw #8 x 3/8" (2)
Lag Screw 5/16"-18 x 1-7/8" (4)
Carriage Bolt 5/16"-18 x 2-1/2" (2)
Clevis Pin 5/16" x 2-3/4" (1)
Clevis Pin 5/16" x 1" (2)
Nut 5/16" - 18 (6)
Lock Washer 5/16" (6)
SECTIONAL DOOR
Installation Hardware
Screw 6AB x 1" (2)
Insulated Staples (10)
Ring Fastener (3)
Handle
Dry Wall Anchors (2)
Rail Grease
Rope
To avoid damage to the garage door and
opener, disable locks before installing and
operating the opener. Use a wood screw or nail
to hold locks in the "open" (unlocked)
position.
Operation at other than 120V 60 Hz will cause
opener malfunction and damage.
Before you begin, complete the following test to
make sure your door is balanced, and is not
sticking or binding:
• Lift the door about halfway as shown. Release the
door. It should stay in place, supported entirely by
its springs.
• Raise and lower the door to see if there is any
binding or sticking.
ONE-PIECE DOOR
Lag Screw 1/4 x 1-1/2" (4)
Hex Screw 1/4-20 x 1-1/2" (2)
Carriage Bolts 1/4" - 20 x 1/2" (4)
Screw #10 - 32 x 3/8" (4)
Lock Nut 1/4" - 20 (4)
Lock Nut #10 x 32 (4)
Wing Nut (2)
Insulated Staples (20)
3
CAUTION
Test your Door
Safety Reversing Sensor
Installation Hardware
Hide quick links:
Advertisement
Table of Contents
