Table of Contents
Advertisement
Position the runners (A) at the top and bottom of the
inside of the kitchen unit as shown in Fig. and mark
the position of the external holes.
A
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
PR33
Open both the appliance door and that of the kitchen
unit to approx. 90¡. Place the little plates over the
8mm
runners. Hold the doors of the appliance and the unit
together and mark the holes.
PR34
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little platee over the
runners and screw in the screws provided (3.5x16
mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that the
doors of the appliance and the kitchen unit open
properly.
PR35
The doors can be opened using the sliding system
previously illustrated, or one of the two doors can be
opened by fitting the small handle supplied as an
accessory.
D029
21
Advertisement
Table of Contents
